After installing the Connect Tech Board Support Package, additional Jetpack SDK Components are available to be used on your Jetson module. For more information on the NVIDIA Jetpack SDK Components, please click here. The following guide shows instructions on how to install the Jetpack SDK Components on top of the Connect Tech Board Support Package so that our BSP is not overwritten. Please make sure you have fulfilled all of the prerequisites before following the installation steps to add the Jetpack SDK Components.
- Initial setup for the Connect Tech Board Support Package on the Jetson module must be completed. Instructions on flashing our BSP can be found here.
- Jetson module must be turned on and connected to the internet as the packages are installed over ssh.
- Jetson module must not have auto updated packages since the original flash. There is a known issue if you update the nvidia docker package (usually via auto update), the components will fail to flash.
Updated September 24th, 2019